Technique

How to make espresso at home, step by step

· 4 min read · By Nico Varga

To make espresso, grind fresh coffee fine, put about 18 g in the portafilter, tamp it level, and run the machine until about 36 g of liquid is in the cup. That usually takes around 25 to 30 seconds. If it tastes sour, grind finer; if it tastes bitter, grind coarser.

Key takeaways

  • Weigh your dose and your yield. A common starting point is about 18 g in, about 36 g out.
  • Aim for roughly 25 to 30 seconds, but let taste decide.
  • Change one thing at a time, and make that thing the grind.
  • Espresso water reaches the coffee at about 9 bar of pressure, which is why a machine is needed.

What do I need to make espresso?

You need an espresso machine, a grinder that can go fine, and a scale. A grinder matters more than most people expect, because pre-ground coffee is rarely fine or fresh enough. The scale is what turns guesswork into a recipe you can repeat.

You also need a basket that matches your dose. Traditional singles use about 7 g and doubles about 14 g, while many modern home baskets take 16 to 20 g. Follow the rating on your basket rather than forcing in more coffee.

My own setup is a secondhand single-boiler machine and a burr grinder. Nothing in this article needs more than that. For more on gear and technique, see the blog.

How do you make espresso, step by step?

  1. Warm up the machine. Give it time to heat fully. On Pip that is about 20 minutes, so I switch it on before anything else.
  2. Weigh the dose. Grind about 18 g, or whatever your basket is rated for, straight into the portafilter or a cup.
  3. Level the grounds. Tap or shake gently so the bed is even, with no mounds.
  4. Tamp. Press down level and firm. Even matters more than hard.
  5. Flush and lock in. Run a little water through the group, then lock the portafilter in quickly.
  6. Start the shot and the timer. Put the cup on the scale and tare it.
  7. Stop at the yield. Stop near 36 g in the cup, which is a ratio of about 1:2. That ratio is a common starting point, not an official standard.

Write the result down as a shot line: 18 g in, 36 g out, 28 s. That one line is what you adjust next time.

What temperature and pressure should espresso use?

Pressure at the coffee is usually about 9 bar. The Italian Espresso National Institute lists about 9 bar, plus or minus 1, for its certified espresso. Many machines advertise a higher pump number, but that is the pump rating, not what the coffee sees.

For temperature, the same parameters give about 88 C at the group, plus or minus 2 C. Many home recipes sit roughly between 88 and 96 C depending on roast, which is a common home range and not a standard. Start at around 93 C if your machine lets you set it, a bit lower for dark roasts and a bit higher for light ones. If you cannot adjust it, do not worry; grind and dose matter more.

How do I fix a shot that tastes wrong?

Time and taste tell you what to change. Adjust only the grind, one small step at a time, and keep the dose the same.

  • Too fast and sour: the water rushed through and under-extracted the coffee. Grind finer.
  • Too slow and bitter: the water struggled and over-extracted it. Grind coarser.
  • Spraying or uneven flow: this is often channeling, where water finds a crack and punches through instead of flowing evenly. Level the bed and tamp evenly.

Pip ran 31 seconds one morning, three too slow, so I went one step coarser and it came back sweet. The cause was the grind, not the machine.

Extraction yield, the share of the coffee that ends up dissolved in the cup, is commonly cited at about 18 to 22 percent as a target for most traditional coffee drinks. You do not need to measure it at home. It explains why too fast tastes sour and too slow tastes bitter.

How do I keep my results consistent?

Use the same dose, the same yield and the same routine every time. Change one variable per shot, and write down each shot line so you know what you did.

Fresh beans help too. Coffee loses flavor as it ages, and stale beans make dialing in frustrating because the target keeps moving. When you open a new bag, expect to adjust the grind again.

Keep the machine clean and descale it according to its manual, with the interval tied to your water hardness. I do not give a fixed interval because it depends on your water. For how I handle a new bag, see the blog, and for who writes this site, see the about page.

Learn more about how I dial in a new bag

Written and tested on my own counter.

More in Technique

Everything in Technique